FLAME PHOTOMETER - MICROPROCESSOR BASED.

FLAME PHOTOMETER - MICROPROCESSOR BASED.

Complete with Sodium (Na) & Potassium (K) filters, 5 Point Calibration, Direct Readout in ppm & meq/l, auto filter section, auto ignition, 20 x 4 lines LCD displat, Single Aspiration, RS232 interface & printer attachment facility.
It is supplied with compressor and other accessories.
Range	:	(ppm)		(meq)
		Na	:	0-100 Up to 250 meq/l, 1:100 dil
		K	:	0-100 Up to 250 meq/l, 1:100 dil
		Ca	:	0-100 Up to 250 meq/l, 1:100 dil
Sensitivity.	:	Na : 0.1ppm, K : 0.01 ppm, Ca : 0.5 ppm
Units	:	ppm, mg and % age Selectable.
Filter Selection	:	Na & K and Ca by Microprocessor
		controlled stepper motor.
Reproducibility	:	± 1% of FS ± 1 Digit.
Curve fit accuracy	:	± 2% of FS
Display	:	Large 20 x 4 Character LCD display with
		backlit.
Aspiration time	:	4-5 Seconds
Flame system	:	LPG & Dry oil free air
Detector	:	Photodiode
Calibration	:	Up to 5 point calibration with curve
		fitting software
Gas Control	:	Adjustable with knob
Ignition system	:	Auto ignition
Fuel Gas	:	LPG
Burner	:	Stainless Steel
Dimensions	:	365 X 245 X 220 mm Approx. (LxBxH)
Air Compressor	:	With Built-in Regulator and Air Filter to deliver
		stable and moisture/oil free air supply
		@ 1 Kg / cm²
Air Supply	:	By oil free Mini Compressor Unit With
		Pressure Regulator
Weight	:	Main Unit : 8 Kg. (Approx) compressor :
		6.5 kg. (Approx)
Power Supply	:	95 to 270V A 50-60 Hz with inbuilt
		stabilizer
Accessories	:	Compressor with built-in air regulator and air filter to deliver stable
		and moisture free air supply @ 1 Kg / cm², 1 mtr. Capillary Tube, 2
		mtr Gas Connector Tube, 0.5 KVA Stabilizer already in-built in the
		system.